1
General Mach Discussion / Can't change feed override value
« on: October 09, 2013, 02:57:25 PM »
Hi,
I can't seem to change the override value on the FRO. It stays at 7% no matter what.
The arrows don't move it and when I code, say, F380, it sticks to 26.6. If I hit the reset button inside the FRO panel, it will speed up to F380 until the next line then go back to 7% and I have to keep hitting reset to make it go to the speed I have set in code. I can't do this while actually cutting a part of course because it jerks due to the speed change.
How can I fix this?
David
I can't seem to change the override value on the FRO. It stays at 7% no matter what.
The arrows don't move it and when I code, say, F380, it sticks to 26.6. If I hit the reset button inside the FRO panel, it will speed up to F380 until the next line then go back to 7% and I have to keep hitting reset to make it go to the speed I have set in code. I can't do this while actually cutting a part of course because it jerks due to the speed change.
How can I fix this?
David