1
General Mach Discussion / How to resume cutting from a spot where axis motors stopped
« on: October 24, 2017, 05:26:25 PM »
my machine axis motors stopped moving , I could see the gcode line in Mach 3 still continuing scrolling down. I stopped the feed and then clicked on Stop button. Noted the gcode line# .My power supply felt very hot .Suspect its overheating caused the motors to stop moving. SHUT EVERYHTING DOWN TO LET COOL OFF.
Saved fixtures work offset before shut down all.
I know where on material the motors stopped .How do I start from that spot again in mach 3 after all is cool down again? Don't want to have to restart from very beginning again as program was about 4 minutes from finishing .
Been looking in the manual but cant seem to find a direction in there . Any help appreciated.
Thanks
Andy
Saved fixtures work offset before shut down all.
I know where on material the motors stopped .How do I start from that spot again in mach 3 after all is cool down again? Don't want to have to restart from very beginning again as program was about 4 minutes from finishing .
Been looking in the manual but cant seem to find a direction in there . Any help appreciated.
Thanks
Andy