1
General Mach Discussion / Help needed - My servo motor only runs in One direction when using Mach3
« on: May 07, 2009, 07:05:01 AM »
Anyone can tell me why my servo motor can only in one direction.
When i run mach3, it moves in one direction and then stop and then the same direction. Whenever the Axis drops value, the motor stop. It should be turning opposite direction, but it doesn't. Why? Can anyone tell me pls...
Another question how does mach3 knows i am using servo or stepper motors? How does it configure the output and motor signals?
When i run mach3, it moves in one direction and then stop and then the same direction. Whenever the Axis drops value, the motor stop. It should be turning opposite direction, but it doesn't. Why? Can anyone tell me pls...
Another question how does mach3 knows i am using servo or stepper motors? How does it configure the output and motor signals?