Guest
Show Posts
1
Building or Buying a Wood routing table.. Beginnners guide.. / Start /stop spindle with software
« on: May 30, 2023, 06:01:01 PM »
Hello, I am new to this website, so go easy please.
I am looking to buy a 500W GRBL controller with a USB port to connect to my laptop. This will replace my old damaged controller. Problem is, there is no spindle stop/start switch or speed control knob.
Can anyone please advise any CAM software that will generate G.Code to do this ? I have been using Aspire to generate G.Code, but there is no stop/ start feature in that.
I use UGS to run the control box
I am looking to buy a 500W GRBL controller with a USB port to connect to my laptop. This will replace my old damaged controller. Problem is, there is no spindle stop/start switch or speed control knob.
Can anyone please advise any CAM software that will generate G.Code to do this ? I have been using Aspire to generate G.Code, but there is no stop/ start feature in that.
I use UGS to run the control box