Messages

1

Mach4 General Discussion / Re: Jogging multiple Axes

« on: July 22, 2022, 06:27:29 AM »

It is possible and the question has been solved.  Thanks.

2

Mach4 General Discussion / Re: Jogging multiple Axes

« on: July 20, 2022, 08:30:41 PM »

I thought that was the right way , I just didn't know how to execute it.  Thanks!

3

Mach4 General Discussion / Re: Jogging multiple Axes

« on: July 19, 2022, 04:37:43 PM »

I have a 4 axis foam cutter that moves a wire in two planes.  2 that move in the y plane and 2 that move in the z plane.  Instead of holding the two keys on the keyboard simultaneously, I would like to use one button to move each set of axes.

4

Mach4 General Discussion / Re: Jogging multiple Axes

« on: July 19, 2022, 04:23:50 PM »

Thanks but that's not what I need to do.  I want to JOG two axes with one button.  Your response is not an option.

5

Mach4 General Discussion / Jogging multiple Axes

« on: July 17, 2022, 05:05:49 PM »

Is there a way to program a button to jog two different axes at once, such as X and Z?

6

Mach Screens / Screen Buttons

« on: July 17, 2022, 02:21:28 PM »

Is there a way to jog 2 axes with one button?

7

Mach4 General Discussion / Re: Lua Error

« on: September 17, 2021, 10:29:28 PM »

It happens on a clean installation with the only addition is the plug-in for my PMDX controller.  In the profiles created by Mach4 there is no problem.  The Profiles created by The PMDX plug-in installer all have the same problem.  I don't know what it changes when it installs.  It is the latest build for both PMDX and Mach4.

8

Mach4 General Discussion / Lua Error

« on: September 17, 2021, 07:50:19 PM »

Whenever I load my PMDX profile and press the "Enable" button I get an error that states "Lua: Error occurred while opening file cannot open C:\Mach4Hobby\Profiles\PMDX416\Macros\mcLua.mcc"

PMDX416 is a profile I created by copying the PMDX sample profile.  I have ensured that the file is in the directory but have watched it get deleted from the directory when loading the screen.  Why is the file getting deleted when loading the screen?

9

Mach4 Plugins / Mach 4 and Pokeys MPG

« on: June 06, 2021, 10:39:42 AM »

Having an issue with an MPG connected thru PoKeys.  When the increment is set to 1.0000 or 0.1000 the axis starts to move but then almost immediately returns to its starting point.  Sometimes it even goes back more in the opposite direction I am trying to move it.  The MPG is connected to pins 1 and 2 of the Pokeys as directed in the PO Keys manual.  Has anyone else seen this?