1
General Mach Discussion / Re: Spindle relay control is confiigured, but M3/M4 won't turn on the spindle...
« on: April 24, 2016, 11:11:12 PM »
Never mind... Sorry!
The "Output 1" line in "Ports & ins" "Output Signals" had to be enabled set to port 1 and pin 1
and the polarity selected, as well as the settings in "Motor Outputs" and "Spindle Setup".
Getting the axis motors set up and limit switches configured was a breeze compared to getting
the spindle to spin.
Whew. But it works now.
Thanks!
The "Output 1" line in "Ports & ins" "Output Signals" had to be enabled set to port 1 and pin 1
and the polarity selected, as well as the settings in "Motor Outputs" and "Spindle Setup".
Getting the axis motors set up and limit switches configured was a breeze compared to getting
the spindle to spin.
Whew. But it works now.
Thanks!