1
Show"N"Tell ( Your Machines) / Re: The Laser Project.
« on: December 31, 2013, 07:15:43 PM »
Hi guys and thank you Tweakie for this great plug-in.
Total NOOB here and I am just getting started with laser engraving.
I have tested it by engraving simple shapes and it works perfectly.
I do have a question...
Is there any way to make the engraving from top to bottom, instead of bottom up?
Any info would be greatly appreciated.
Thank you.
Total NOOB here and I am just getting started with laser engraving.
I have tested it by engraving simple shapes and it works perfectly.
I do have a question...
Is there any way to make the engraving from top to bottom, instead of bottom up?
Any info would be greatly appreciated.
Thank you.