Messages

1

Third party software and hardware support forums. / Re: Motors heating up

« on: June 23, 2011, 07:30:58 AM »

THX Rich.
You were right. The current is too high.
But I bought 2 stronger motors (1.2 Nm) with higher current rating and now it seem that the smaller motor isn't heating up anymore, nether are 2 new motors.
Problem solved.

2

Third party software and hardware support forums. / Re: Motors heating up

« on: May 25, 2011, 03:44:32 PM »

No.
There are dip switches on the controller board that are used to regulate current.

3

Third party software and hardware support forums. / Re: Motors heating up

« on: May 25, 2011, 01:59:31 PM »

Oh and one more thing.
I've just clicked "REF ALL HOME" in mach3 and Z axis motor started turning, others were still but had a good hold torque. I left it to turn for a few minutes and it remained completely cool but other two started getting warmer. While it was turning I've checked voltages between A+ and A- then B+ and B- on each motor.
Those two that weren't turning had 8V between A+ and A- and 8V between B+ and B-, but Z axis motor that was turning showed 0V on all.

I've set current setting on 25% (lowest) and decay mode on SLOW on the driver dip setting board
Micro step setting is 1

4

Third party software and hardware support forums. / Motors heating up

« on: May 25, 2011, 01:48:06 PM »

Hi everyone.
I'm a new member, just bought TB6560 Driver and 3 Nema 17 steppers on e-bay for my first CNC.
Construction is nearly done, but I wanted to test the electronic.
I connected the driver to PC and started Mach3 mill.
I've configured it like the manual says (the one I got with the driver)
I've loaded roadrunner.tap G-code and started it.
The motors started turning, and everything looked fine.
I took about 6 minutes to complete.
But there's a problem.  The motors heat up really bad.
They are cold when they work, but when they stop they get hot pretty quickly.
In those 6 minutes they were cold, but when the program ended they heated up
in like 5 minutes so hot I couldn't touch them for more than half a second.
I use 24V 10A power supply but I've set voltage to 9V (checked with multimeter)
On the motors it says 11V
Motors are 17PM-K301-11V
They have 6 leads but I've connected 4 (4 connectors on the board for each axes)
I've connected leads like this

1 - A+
2 -
3 - A-
4 - B+
5 -
6 - B-

So 2 and 5 are not connected to anything.
All leads are colored gray, but I've checked short circuit with multimeter on A+ and A-
then B+ and B- to be sure they are of the same coil and they are.

How can I fix this?
I don't think a machine should work with motors so heated up.