1
dspMC/IP Motion Controller / Voltage Output on M3
« on: December 23, 2010, 09:14:46 AM »
Hi all.
I seem to be having trouble with the 7535 break out board on my interpreter 1000.
For some reason I am getting an output voltage on M3 even when all outputs are disabled, including port 1, pin 1, which should control that specific output.
All the other outputs change properly.
I have updated the firmware and the mach 3 plugins.
Any help would be much appreciated.
Thank you
I seem to be having trouble with the 7535 break out board on my interpreter 1000.
For some reason I am getting an output voltage on M3 even when all outputs are disabled, including port 1, pin 1, which should control that specific output.
All the other outputs change properly.
I have updated the firmware and the mach 3 plugins.
Any help would be much appreciated.
Thank you