Machsupport Forum
G-Code, CAD, and CAM => LazyCam (Beta) => Topic started by: atanq on December 29, 2008, 01:09:54 PM
-
Hello,
I have the following .Lcam file, which is a guitar scratch plate. However, when I try to lazy cam it, I get multiple chains for the main outline. I would like it to cut in one continuous motion. Anybody got any ideas?
I'm using LCam Version 3.00.
Thanks in advance, Guys
-
here is a cleaned up lcam for you. lcam is a beta with many bugs. it can't handle that much confusion.
-
That's amazing!!!
Please tell me how you did that, friend.
Aaron.
-
Hi,Aaron
that is a lot of explaining.if you look at the lcam you posted,at the chain and layer menu on the left you will see a pretty good list of stuff.then look at the menu of the lcam i sent you.that shows how much stuff had to be deleted.then i had to
connect all of the broken chains that i could.the chains that would not connect had to be repaired .the repairing process went like this.i took what was cleaned up and made a g-code and loaded mach.then i used the text editor to remove rapid moves
and connect the broken chains.imported the g-code back into lcam and generated you a lcam file.your dxf was a sad one.lcam has a lot of power,but is very sensative to bad drawings.the more you play with it the better it gets. lcam cannot
repair a bad drawing and it can have trouble with a good one.when you get you drawings down to where their are pretty good lcam can write a ton of code for you.i got lcam jerked around to do 4th axis stuff to.good luck to you!
bill
-
Hi Bill,
Thanks for that, I guess the way forward is to ensure a proper .dxf in the first place. I looked at my original .dxf and found that there were quite a few breaks in the lines when zoomed in close-up. Now, I can go straight from my .dxf into lazy cam!
Thanks for all the help, Bill.
-
Bill's the man, for sure.... 8)
Dave
-
Hi, Aaron
Posting your .dxf file also help's us help you better as the issues most often start there.
Thanks, Chip
-
Splendid help, everyone.
Is there a way to mark this topic as closed?
Thanks,