Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: archerks on December 24, 2008, 04:11:53 PM
-
I have a new computer that did not have an LPT port, so I added a card. When I run the GetPortAddress.exe it reports an address of &HDCA8.
In Mach3 what do I put in the Port #1, Port Address box?
Thanks,
Dave
-
Would think it would be DCA8 but you should be able to see it by going to device manager and checking the resources tab for that port.
Hood
-
Device Manager has I/O Range DCA8 - DCAF
If I type in DCA8 in the Mach3 Port Address box and apply, it changes it to 0xdca8
I imagine that is the correct address as the default for Port1 is 0x378
Dave
-
yes thats it :)
Hood
-
Thanks Hood,
Just needed a little reassurance.....
Dave