Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Marwellca on December 19, 2008, 06:11:51 PM
-
Howdy all,
I recently purchased a used CNC Router with a DSP Controller system. I can't say that I like the DSP at all. Not enough feedback for me. How easy would it be to change the DSP controller to a computer hookup that I could run with Mach 3?
Keeping in mind that I am pretty much electronically illiterate I need to find a system that would be fairly easy to install.
The CNC is a Chinese unit that runs with 3 steppers and is 110 volts but 3 phase.
Martyn.