Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: will1234 on December 08, 2008, 06:35:22 PM
-
Does anyone know of a post that will work with Mach3 without requiring a lot of modification? Either to post Catia NC output or convert APT output. Is tracking down a post processor generator worth the effort?
Thanks in advance,
Will
-
$8000 will get you one from DS, if you have a Fanuc 6 post that one will be very close
Graham
-
Will,
Send me an email, I may be able to help you convert apt to g code suitable for Mach3.