Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: DennisCNC on December 03, 2008, 11:32:23 AM
-
This is in Mill Screen:
I have the UP/Down inputs emulated and the LEDs in Diag. tab light up and the THC move is enabled in Mill tab in ports/pins. And only the down works when running code but not up? the LEDs light up for up and down.
Do I need to mess with the THC min max DRO's?
The up/down works ok in Plasma screen. But I need it in Mill screen.
Ver. 3.042.020
Thanks
Dennis
-
Never used it so dont know but you can add the DROs that are on the plasma screen to the mill screen and it might help.
Hood