Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Freff on November 29, 2008, 03:57:51 PM
-
I've done something wrong or inadvertently reset something, but I just can’t figure out what it is. Everything was running fine until I tried to jog to a new position. The machine jogs so slow it's painful. Actual cutting is no problem and it appears to run as normal. The jog rate is set to 100%. I have increased Vel and Acc, the pulse rates and debounce to no avail. I have tried it in both inches and metric, the same.
I'm at a lose to think of anything else at the moment, perhaps someone could help me out with this please.
Thanks Tony
-
Can you attach your xml please.
Hood
-
Here you are Hood.
-
Thanks but afraid that seems to be the wrong XML or its corrupt :( Please try again.
Hood
-
I'm having trouble uploading it. Keeps telling me file already exist. How do I correct or shall I email it to you.
Tony
-
Have sent you a PM but just for your information the forum will only accept a file once so if one of that name has already been attached you need to rename your file and try again.
Hood