Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: seanreit on November 22, 2008, 03:06:44 PM
-
and then the code takes it to 4200 for finish pass or something and
then the code takes it to 3500, the spindle slows to a stop.
anyway around this? It will speed up, but will not slow down, it
will only stop if a lower rpm is chosen.
i just now checked that if i manually set spidle to 4000 and click the spindle speed down button, it shuts it off. this is on a tormach.
can anyone duplicate this?