Machsupport Forum

Third party software and hardware support forums. => SmoothStepper USB => Topic started by: Anton on November 20, 2008, 04:33:06 PM

Title: Override Limits issue - does it relates to SS?
Post by: Anton on November 20, 2008, 04:33:06 PM
Just discovered that manual "Override limits" does not work. Red led flashes, I push a Reset button, but I can't jog out of the switch. The same time AutoOverride Limits works well, homing works well, limit switches themselves works well. Everything, concerning a limit switches, works well, except of a manual Override limits. Does it relates somewhere to SS?
Title: Re: Override Limits issue - does it relates to SS?
Post by: Hood on November 20, 2008, 04:39:42 PM
Not sure, I always have Auto enabled.  If no one else comes back with an answer I will try and remember to test tomorrow if I get back to the workshop in time, if not it will be Saturday.
Hood
Title: Re: Override Limits issue - does it relates to SS?
Post by: sshneider on November 22, 2008, 04:02:08 PM
It works but it's funky.  You have tho click the reset button 2 times.  Then it should allow you to move off your limit switch.

HTH,
Sid
Title: Re: Override Limits issue - does it relates to SS?
Post by: Anton on November 22, 2008, 04:02:43 PM
Today I have tried this with PP version and manual limits override works well.
Title: Re: Override Limits issue - does it relates to SS?
Post by: Anton on November 22, 2008, 04:05:07 PM
It works but it's funky.  You have tho click the reset button 2 times.  Then it should allow you to move off your limit switch.
Thanks, I'l bear it in mind.