Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Ron Ginger on November 10, 2008, 05:47:37 PM
-
A new document for Installing and setup of MAch3 is now on-line See http://www.artsoftcontrols.com/docs/Mach3Mill_Install_Config.pdf
This is a doc that needs to be read and followed step by step. I covers everything a beginner needs to get a mill running.
We hope to have paper copies for sale at the Cabin Fever workshop and on-line.
-
That would be very nice to have a hardcopy of this, hope to see/meet you at the show, Ron- :)
Dave
-
Might be helpful to be a sticky.
-
Well, here goes another day about every body bitching that I'm tying up the printer at work.
Maybe I'll put a face page saying it's improved work practices to be implemented by year end. ;D
Oh, BTW, is this mandatory reading prior to the Cabin Fever seminar. ???
RICH