Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: nilesh on November 05, 2008, 07:27:27 AM

Title: mach3 for laser
Post by: nilesh on November 05, 2008, 07:27:27 AM

Dear all,
      We are trying to using the dmc 2123 controller(galil) and mach3 software for laser system.
      We saw setting for mill in mach3. But we are not able to get proper setting to interface laser.
      We only need to one out put from mach3 to turn on or off laser
       Please provide the detail solution as soon as possible.

Thanks Regards,
Nilesh Deshmukh
exceltech southasia
Andheria,(E),Mumbai
Mumbai, Maharastra  400068
India
Phone: 91-022-28222323
nilesh@exceltech-southasia.com

Title: Re: mach3 for laser
Post by: HillBilly on November 06, 2008, 07:12:18 AM

The solution that comes to mind for Mach3 Mill is to set up spindle relays and use M3 for ON and M5 for OFF.

Thanks, Darek