Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: seanreit on November 04, 2008, 06:05:38 PM
-
Say I put an edge finder in the machine and then set spindle to 2000 RPM and hit "spindle". It takes about 5 seconds before I can jog to a new position.
I need that to be zero, cause when I try to tap at the bottom of the tap, the machine runs the spindle in reverse, bud does not feed back up till it runs the spindle for about 5 seconds destroying the threads I just put in.
-
Config menu then Ports and Pins then Spindle Setup, you can set the spin up/down delays there, put it to 0 and it should be almost instantaneous.
Hood
-
Thank you, that worked perfect!