Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: giordano on December 18, 2005, 06:21:47 AM

Title: Tool compensation
Post by: giordano on December 18, 2005, 06:21:47 AM

Hi. How him imposed the compensation of the diameter of the utensil when for example with a cutter of 2.5 mms of diameter a circle of 32.5 mms of diameter is gotten instead of 30 mms of diameter? Thanks. Giordano.

Title: Re: Tool compensation
Post by: Graham Waterworth on December 18, 2005, 08:42:21 AM

Hi

it sounds as if you have got G41 instead of G42 or vise versa.

Regards

Graham