Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: dougie329 on July 01, 2006, 05:33:45 PM

Title: 2 motors driving x axis on router
Post by: dougie329 on July 01, 2006, 05:33:45 PM

I have 2 motors driving the x axis and they have a seperate plug each into the controller. what do i need to do to get them running in sync. Do I set up a new axis, say the A axis? or should they both be driven from the x axis setup? I dont want 1 motor to move on its own and pull the router gantry accross!! ???

Title: Re: 2 motors driving x axis on router
Post by: Brian Barker on July 01, 2006, 09:27:11 PM

under Config there is a place to slave an axis...