Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: JAMMAN on July 01, 2006, 12:21:07 PM
-
I feel dumb, the drive works and the homing and limits work and everything seems smoothe till I tried to make an external reset. I was going to use an oem trigger but evidently I don't know the oem code.
I need an output also when in e-stop mode, haven't even tried it yet. Any suggestions? I did a search and didn't find anything.
Jim
-
I think the OEM code is 1021 :)
To get the Estop out you will need to make a Macropump ... I can help you if you need it
-
Great thanks, I'm at home right now and will try the OEM code first thing Monday morning.
You wouldn't happen to know the one for cycle start too? ;D
Anyway I'll read up on the macro pump thing this weekend so I won't seem like such an idiot then I'll catch on better.
Thanks for your help- I'll post a picture of my micro hole driller when I'm done with it.
I also found a place with really cheap IO cards that I made work with Mach3, I'm talking less than 20 bucks for 4 relays. If anyone is interested I'll post a link.
-
You will find a list of OEMS etc in the customisation Wiki, heres a link
http://www.machsupport.com/MachCustomizeWiki/index.php?title=Main_Page
-
Cycle start is 1000 :)
-
OEM codes worked perfectly (of course) ;D
At least I can cycle the thing and get it set up mechanically now. After I get it going then it's Macro Pump time. Whatever that is..........
Thanks again!
Jim