Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: XLR84x4 on October 25, 2008, 09:43:55 PM
-
I can seem to find what bug fixes were done in version R3.042.015n
Iam hoping that CV for tangential axis has been implemented.
Jason
-
Dont think that has been done, the last few Dev versions have been fixing the long running VB interface problems, lathe threading and a few other odds and ends. Think there will be a list of fixes when it becomes a lockdown.
Hood
-
Cutter comp is at the top of the to do list according to Brian.
Graham
-
Brian:
Just downloaded and ran 3.042.015 and have the same issue previously reported regarding 3.042.004 (see below). The part was cut correctly, but looking at the weird numbers in the Tool: Table Display screen was really disconcerting. Have gone back (again) to 3.041.
Previous post follows:
Downloaded and ran 3.042.004 version and had nothing but problems. Code that ran perfectly in version 3.041 would not run without problems in arcs, etc. One thing I noticed on the Diagnostics screen is the abs max x, y, z were all out of proportion to the drawing in the code in mill mode. The figure in the code is 11.5 by 5.5 inches - the Diagnostics screen showed the max to be like 116 (somethings). Yes, I copied my old xml file into Mach before running the code. Yes, my native limits were in inches. I had the same problem with another code.
Bob @ BobsShop