Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: nilesh on October 23, 2008, 12:54:49 AM

Title: problem limit switch motion
Post by: nilesh on October 23, 2008, 12:54:49 AM

hi all
i am using the galil 2123 controller with mach3 software.
i have problem limit switch. when ever my limit switch interrupt my hole motion get stop even my reverse,forward motion.
example:  if my reverse limit interrupt my motion get stop then i am not able to move motor in forward/reverse direction.
again i have to manually reset my limit switch by moving motor manually.
please provide the solution.

Title: Re: problem limit switch motion
Post by: Hood on October 23, 2008, 02:58:36 AM

Does AutoLimit Override not work for the Galil, you will find it on the setings page.
Hood

Title: Re: problem limit switch motion
Post by: nilesh on October 23, 2008, 05:50:10 AM

thanks hood
auto limit works for galil.
can you give the detail path where i can set auto limit override option.

Title: Re: problem limit switch motion
Post by: Hood on October 23, 2008, 05:59:55 AM

If you look on the left hand side of the settings page you should see the option for turning them on.
Hood

Title: Re: problem limit switch motion
Post by: nilesh on October 23, 2008, 06:41:53 AM

i have set auto limit override button. then i try to move motor after limit interrupt using ( up/down button ) joging .
but didnot work.

Title: Re: problem limit switch motion
Post by: Hood on October 23, 2008, 06:54:07 AM

Did you press the Reset button after you hit the limit? If you did then it looks like the Galil must do things differently.
Hood