Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: nilesh on October 13, 2008, 08:49:44 AM
-
hi all
i am using the galil plugin with mach3 for our servo xy motion system.
my problem is motor is moving in reverse direction.
if i put G0X10 motor will move in reverse direction.
i try with ports and pins->motor output . i reverse the direction low active setting. but it didn't worked.
please send link for a pdf or other document for setting a galil board for MACH3 software.
-
Change the Direction from Homing and limits page.
Hood