Machsupport Forum

Third party software and hardware support forums. => Promote and discuss your product => Topic started by: Weerasak on October 09, 2008, 12:05:01 AM

Title: It's time to drive with MachDrive
Post by: Weerasak on October 09, 2008, 12:05:01 AM

Dear Members,

MachDrive is a result of my enthusiastic hobby. First I designed it for my own need, I needed a compact size and include basic necessary things
inside. Later I found that it could be sold, hopefully.

The MachDrive is CPLD-based, using LMD18245 proven reliable driver chip, 4 axis bipolar microstepping motor driver, able to drive up 3Amp 48 Vdc. All in one design including opto-isolated parallel port interface, charge pump, idle current reduction, high output current for driving external relays, all are packed inside small footprint of red anodized aluminum heat sink housing with convenience pluggable screw terminal. Works with Stepper and Direction controller software such as Mach2, Mach3.

               (http://www.cncroom.com/images/machdrv1.jpg)

Detail here-> http://www.cncroom.com/index.php?main_page=product_info&cPath=1&products_id=1&number_of_uploads=0&language=en

VDO here -> http://www.youtube.com/watch?v=vSwU62f35Kg


Best Regards,

Weerasak

Title: Re: It's time to drive with MachDrive
Post by: Weerasak on November 12, 2008, 12:53:42 AM

Dear All,

Updated MachDrive English Manual at CNCRoom

http://www.cncroom.com/forum/index.php/topic,25.0.html

Thank you

Weerasak