Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Pierke on October 07, 2008, 05:42:31 PM

Title: Has anywone rebuild a Emco cnc turn 5 to Mach?
Post by: Pierke on October 07, 2008, 05:42:31 PM

Has anywone rebuild a Emco cnc turn 5 to Mach?
What can i using from the old electronic from the Emco machine? Sombody an aidee?

Pierke

Title: Re: Has anywone rebuild a Emco cnc turn 5 to Mach?
Post by: Chaoticone on October 07, 2008, 06:04:23 PM

Below your info at the top of the page there is a search box. Type this in and do a search.  Emco 5
I think you'll find lots of info.

Brett