Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: pbreed on June 19, 2006, 01:56:09 PM
-
Can Mach 3 do Thread milling?
If so what hardware support is required from the spindle?
An index pulse, a series of pulses like the lathe?
Anyone have any Guidance on setting this up?
-
Hi
No special hardware support is needed. The pitch on thread milling is not dependent on the spindle revolution's like on a lathe. The pitch in thread milling is normally measured on the Z axis and this is done internally in Mach3,through the interpolation between the different axis involved.
Hope this helps
Deon
-
Hi
Forgot to mention that the Newfangled Wizards has fabulous Thread milling capability's.
Have a look at the demo conversational Wizard in Mach 3...
Cheers