Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: sommerjd on October 01, 2008, 04:51:01 PM

Title: Unidex 511 Motion Controller
Post by: sommerjd on October 01, 2008, 04:51:01 PM
Is anyone familiar with the Unidex 511 Motion Controller?  I have one that I picked up at a excess sale and was wondering if g-code can be downloaded to this controller to run some servo motors.  I have a variety of AC servo motors, but need to know if this will run g-code.
Title: Re: Unidex 511 Motion Controller
Post by: ashish on October 03, 2008, 04:32:49 AM
Flyer says yes it does accepts native G-code