Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: sooperdrave on October 01, 2008, 02:03:01 PM

Title: spindle drive motor not working properly
Post by: sooperdrave on October 01, 2008, 02:03:01 PM
i was in the middle of making a cut with my saw when the spindle just quit on me.  the spindle drive has power going to it but it isn't turning on. i have tested all of the fuses and they seem fine.
also i tested the voltage going to the spindle controll and it was fine.  any ideas?   please help!

Dave