Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Flash Gordon on September 28, 2008, 12:48:25 PM

Title: Gecko 340 Fault Light
Post by: Flash Gordon on September 28, 2008, 12:48:25 PM
Hi All

I have finally got round to wiring up my gecko drives. When I power up the system the fault light on the Gecko Drive will not go out. I have Err/Reset & ENC+ wired via a reset switch.

Should the system be grounded or earthed.

Does anyone have any ideas about what is wrong

Regards

Flash
Title: Re: Gecko 340 Fault Light
Post by: Flash Gordon on September 28, 2008, 02:47:25 PM
I have found the problem. The reset switch has to be held in for atleast 3 seconds