Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Psad on June 14, 2006, 03:13:29 PM
-
Having a little trouble with the Alt5 setup screen. When I put in a value for the Diameter of the edge finder (.200) the coordinate system only jumps .050". I think is should read .100 instead.
Am I doing something wrong or
Did i misunderstand the use of the setup tool or
Is the math routine wrong. ???
-
it works here :) Be sure that you are looking at the Axis Pos on the right hand side of the screen.
If it still is giveing you trouble , upload the set file to the forum and i will take a look at it :)