Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Dt842 on June 14, 2006, 02:30:33 PM
-
I can do one line text okay but how do I get 2 lines
I now there is a way to do it using a sub program but I don't now very much about writing code
Thanks Dick
-
The Write wizard will only do one like at a time :( I would run the Write wizard a few times, then use copy and past to get the gcode into one file.
-
Hi,
if you want lots of text have a look at this working demo, it outputs G-Code.
http://members.aol.com/m9685123/Mdemo.htm
Graham.