Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Mikelivos on September 23, 2008, 02:55:10 PM

Title: Only loads 500 lines of code at a time
Post by: Mikelivos on September 23, 2008, 02:55:10 PM

We have a liscensed and regestered version of Vcarve pro. After exporting code as a .tap file, then importing the file into Mach III, the file will get to line 500 then repeat the line for the remaining file thus not finishing the run.

Please help.

Title: Re: Only loads 500 lines of code at a time
Post by: Hood on September 23, 2008, 03:33:38 PM

Is Mach a demo? if so it is limited to 500 lines of code for Mill and 150 for turn.
Hood