Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: bbrown2005 on September 20, 2008, 06:17:27 PM
-
hi, iwas wanting to hook up an edge finder to tell mach 3 were edges are is thier any thing special i have to do to make it work i have seen a couple video's on u tube but i did not know how to setit up and use it with mach 3 thanks ben
-
Zarzul on the forum makes and sells touch probes, have a look here http://www.machsupport.com/forum/index.php/topic,5004.0.html
Hood
-
thanks ill check them out