Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: scudzuki on September 19, 2008, 09:00:15 AM

Title: Jog capabilities lacking in Mach3?
Post by: scudzuki on September 19, 2008, 09:00:15 AM

I got my recently purchased retrofitted mill, which was delivered with Mach2, to run on Mach3. I cannot find a way to jog in steps within Mach3 like you could in Mach2. The continuous jog works fine via the arrow keys and page up/page down. How do I jog in increments like you could on the manual tab in Mach2 (other than MDI mode running single lines of G code)?
Joe

Title: Re: Jog capabilities lacking in Mach3?
Post by: scudzuki on September 19, 2008, 09:02:58 AM

Nevermind, I was just reading the manual. Found the tab function. Guess I better read the whole manual lest I end up looking like MORE of a fool.
Joe