Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: fixittt on September 18, 2008, 08:24:26 PM
-
anyone have a working XML file for a G540? All I get is a fault light and I need to get the pins set before I pack it up and send it back......
screenshots or something of what ports for what are set......
Getting a new bald spot here......
-
neva mind fingered it out :)
-
Hi. I'm also having problems getting to work a new controller with the G540. I also get the red fault light On. I'm using the xml file from Gecko. I'd appreciate any help you can provide. If possible please send me your xml file. my e-mail is ernie@cadforjewelry.com
Thanks,
Ernie