Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: AngelT on September 18, 2008, 04:24:47 PM
-
When I open an *.nc file made with ArtCam, an entry in the Gcode listing right after the "%" simbol, starts with ":1448"...have to edit the code in order to run under Mach3. Is it a Mach3 or ArtCam problem? After editing the code it runs fine without any apparent problem. Thanks for any clarification.
-
Sounds like the Post Processor in ArtCAM needs editing.
Hood
-
Hood, thanks for your reply. for postprocesor, I am usingĀ a 4 axis listed in ArtCam,Axyz_Arc-INCH(*nc) dont see any 3 axis...maybe that could be the problem...not sure...
-
Afraid I have never used ArtCAM so cant say, maybe someone who uses it will jump in with the PP they use. If not then there might be a utility that comes with it so you can open and edit it to remove that line.
Hood