Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: davy182 on September 11, 2008, 12:13:45 AM

Title: I need to get this done.
Post by: davy182 on September 11, 2008, 12:13:45 AM

man am I not happy, I just updated lazycam and now I bind on at one spot of my machine, but then I move it manually no bind. WHAT THE HECK do I need to change.

Title: Re: I need to get this done.
Post by: davy182 on September 11, 2008, 12:14:23 AM

n70 is where it binds

Title: Re: I need to get this done.
Post by: davy182 on September 11, 2008, 12:28:23 AM

nevermind found out what it was

Title: Re: I need to get this done.
Post by: Kristin D on September 11, 2008, 12:34:55 AM

Mind letting the rest of us know?  ;)

Kristin

Title: Re: I need to get this done.
Post by: davy182 on September 11, 2008, 12:38:18 AM

I moved it in the mdi screen on mach 3 typing in code and was able to reset measurements. someone must have given the machine a hard bump.

Title: Re: I need to get this done.
Post by: Kristin D on September 11, 2008, 12:53:13 AM

Got to keep those type away from the machine! ;D

Kristin