Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: MachBruce on September 07, 2008, 11:09:06 PM
-
I am trying to use Work Offsets as described in section 7.2.1 of the Mach 3 user manual.
Written as follows: "Click the Touch button next to each of the axis in the current Work offset part of the screen".
No matter what I do nothing works as stated.
What the "Touch button"?
Any help please?
Bruce
-
Machbruce'
The "touch button" would be the x-y-z zero buttons on the right side of the off sets page @ REF ALL.
The dros on the left side of the screen shows where you are from machine coordinates for each work offset,
wheather its g54-55 or 56-57-58.
Hope this answers your question.
Ed V
-
That clears it up,
Thanks,
Bruce
-
Wow Ed, has Britt taken off her makeup?
;D
Hood
-
No, she just got in a fight with the dog. ;D
-
She is Hot!!!!!!!!!!! :)
Brett
-
She is Hot!!!!!!!!!!! :)
Brett
Spoken like a true Redneck, man that is your sister!!!!!!!!!! ;D
Hood
-
I thought maybe it was Ed and Britts offspring...and we were not informed of the "Blessed Event".
(for obvious reasons)
RC
-
;D
-
Brett,
Just like lookin in a mirror ? ;D
Ed
-
;D imagine what a family gathering of the Chaotic family would be like, then again maybe it would be best not to imagine it ;D
-
Ahhhhh...Family Reunions. The best place to pick-up DATES ! (IF you are a REDNECK of course)
-
The last family reunion. Typical of any in S.C. ;D
Can you pick out Brett? :D
-
Not sure but I can definitely spot his mother, cousin and sister.
She's the one right at the front ;D
Hood
-
Like they say.....They all look alike to me. ::)
-
Ha ha Brett sure gets some stick ;D
Hood
-
:D R..O.T.F.L.M.F.A.O. :D
-
Ed,
That's quite a family tree you have there in the photo above!
Kristin
-
OOOOH NOOO, It's actually Bretts family. All my inlaws, since I married Bretts twin sister Britt,
Thats enough reason for me not to live in S.C. :D
Ed
-
Looking a little rough there today Ed. Late night with the wife again?
Brett
-
Thanks Brett,
Your such a BUDDY. :D