Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Vmax on December 12, 2005, 09:23:08 AM
-
Does anyone have a list of all the hotkeys that come with Mach3 as installed? I need to printout a training sheet to use. Thanks Terry Parker
-
I think you will find that in the mach2 manual. We made them all the same :)
Thanks
Brian
-
Brian I looked again (Mach2/Mach3) but still can't find a list of the Hotkeys/Function keys. It is not easy to use a mouse at a machine control station. A list of all the function/hotkeys would be very helpfull. Thanks Terry Parker
-
Look at the Customizing manual on pg.51 there is a list of the hotkeys.
Hope that helps
Brian
-
Yes that was what I needed. Thanks Brian Terry ;D
-
Brian is there a source for alternate screen sets? Some of the ones in the cust,mach manual are very nice. I would like to have the screen listed on page 3-8 as my program run screen. Or do we just have to figure it out ourselves. :-) Terry
-
Sorry I don't have them :(
I would give it to you if I did...
Brian