Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: BarryM on August 28, 2008, 09:33:06 AM
-
I just purchased a breakout board from campbell design version 1.9 I connect my Xylotex controller to the board went to campbell design site downloaded the xml file dragged the file to mach3 when I opened up the ports and pin hothing in the drop down menu changed so I entered which I thougt were the right settins for the motors the motors locked up but did not move only the dro's in mach moved I did load the sound logic from the mach3 loader.