Machsupport Forum
G-Code, CAD, and CAM => LazyCam (Beta) => Topic started by: davy182 on August 24, 2008, 11:05:23 AM
-
I did some messing with in lazy cam and found that by messing with the rapid height and plunge clearance it reconfigured the number I am trying to remove. Now there are 2600 plus lines in this tap and I already am not thrilled about removing g0 z.32 out of this program. It is what prevents me from just running the program. If I leave it in it runs the program one hour longer that it should. Any suggestions would be appreciated.
David
-
Hi, David
Check your other post on this
Chip