Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: wintech1 on June 07, 2006, 07:28:07 PM

Title: Cycle Start - Input Signals or an OME Code
Post by: wintech1 on June 07, 2006, 07:28:07 PM

I'm trying to use a start switch instead of going to the Key pad to start the mill, I have got an Estop working but having a little trouble with the Cycle Start.

Thanks
Steve

Title: Re: Cycle Start - Input Signals or an OME Code
Post by: Hood on June 07, 2006, 07:31:35 PM

The customising Wiki has all of the OEM codes listed for DROs Buttons etc.
Hood

Title: Re: Cycle Start - Input Signals or an OME Code
Post by: wintech1 on June 08, 2006, 09:11:56 AM

Yes, this is good, I put the code needed to start the mill and a way it goes.

Thanks,
Steve