Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: gt150 on August 20, 2008, 04:22:14 PM
-
Could some one do me a favor and run this DXF through LazyCam for me. I can get good code with a .187 inside offset and with no offset but I get errors when I try with a .187 outside offset. I would be very grateful.
Steve
-
Steve,
Did you "clean" it first?
This worked perfectly for me but try zooming in on the shape as close as you can or try moving the starting point around to different areas before you offset.
Dave
-
Dave are you a God? If not how do you know these things? I don't know why it worked but it did.
Thank you,
Steve
-
Now I have four perfect parts.
Thanks Again Dave,
-
Excellent, glad it worked out for you, the parts look great!
As for being a God, not quite, it's just all the great help I've gotten from the fine folks here in the past - ;)
Dave