Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: snocutt on August 19, 2008, 02:28:24 PM
-
I'm looking to have small carbon composite parts trimmed, 2 different designs they're about 9x10x1.5 cm overall and the material thickness is 1mm. It would be an initial run of 30-40 pairs.
http://i298.photobucket.com/albums/mm274/snocutt/assem01.jpg
http://i298.photobucket.com/albums/mm274/snocutt/assem02.jpg
-
You asked about this some time back, what has happened, are you still having problems?
Graham.
-
it's mostly about time. I've been a bit busy with other things. I will at some point get a proper router setup, then I'll start having problems.