Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: josh on August 16, 2008, 03:40:32 AM

Title: where can I find the quick keys for a pendant
Post by: josh on August 16, 2008, 03:40:32 AM

hello
I am trying to see where I can find all the codes or short cuts for all the keys on my DRO
I am trying to set my pendant where I only pust a button and it will do as what
I tell it to do. but I dont know what to input on the keygraber box.
i know alt-s is for cycle stop
          alt-r is for cycle start
   spacebar is for feedhold
   and ect.........
i hope this made some kind of sence i really dont know how to explain it.

Title: Re: where can I find the quick keys for a pendant
Post by: Hood on August 16, 2008, 05:44:46 AM

Have a look in the Customising Mach2 manual, it gives you the info if I remember correctly.
Hood

Title: Re: where can I find the quick keys for a pendant
Post by: josh on August 16, 2008, 10:34:40 AM

iam knew to mach and I have only been using mach3
where would I find mach2 customising manual

Title: Re: where can I find the quick keys for a pendant
Post by: Hood on August 16, 2008, 10:39:21 AM

Support tab at the top then documentation then down to Mach2 and you should see the Mach2 customisation manual.

Hood

Title: Re: where can I find the quick keys for a pendant
Post by: josh on August 16, 2008, 02:03:39 PM

thanks finally found it.

Title: Re: where can I find the quick keys for a pendant
Post by: Hood on August 16, 2008, 02:52:22 PM

:)