Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: C. J. Hung. on August 14, 2008, 11:22:53 AM
-
Hi !
I use the Mach3 v2.065 about two more years and everything was good , but I want to use MPG so I upgrade to v2.63 , and got a big
problem about REF ALL HOME , when I hit "REF ALL HOME " , first is Z axis move to home , but when Z touch limit switch , everything
is stop , than " RESET " is blink , I try so many version is same , only v2.065 can work right , is me setting wrong ?
sorry about my English!
Thanks!
Hung.
-
Check that they are enabled and assigned to the proper port and pins.
RC
-
Thanks for your reply , yes , I check so many times , the V2.63 setting is same to V2.065 .
-
Try setting the debounce up to 2000. If that helps, then reduce it to where it is consistant.
-
thanks again , but I don't know what is " debounce " , could you show me where to setting( picture) please ?
-
Under Config/General config
-
Thank you very much! I will try it tomorrow .
-
I set the debounce to 2000 today , and the "REF ALL HOME" function is ok !
Thanks!
-
You might reduce the setting to where it trips and then add a little for a buffer.
rc
-
ok! I will try it tomorrow!
Thank you very much!
-
I reduce debounce to 50 , and all function is ok !
Thanks again!
-
Thats good, the lower you can get it the better, 50 is nearly perfect :)
Hood