Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: giannis121 on August 12, 2008, 02:30:10 AM
-
Hello there!
When changing the FeedOverRide DRO, does that effect also the G0 speed?
It seems to me that when setting this DRO to over than 100%,
the G0 speed also is bigger (and this is problem).
If so, how can i raise the program speed while running, without affecting the G0 speed?
Thanks...
-
That was a fault but it has been cured in the latest versions.
Hood
-
Try:
Config, General Config, In the General configuration, uncheck Lock Rapid FRO to Feed FRO
That would do it
Jeff
-
Jeff
That option is in the versions of Mach that the Rapid speed going over 100% is fixed. What that option does is slow down your rapid rate at the same percentage as your feed rate override. However when increasing FRO the Rapid will not go over 100% even though the feedrate is over 100%.
Hood